Van_Denton
Member
- Messages
- 105
- Location
- Northampton
Hi Guys,
I want to fit a collet chuck to my lathe but Im not sure where to start, I guess I need to make one?
Ive seen this
A L00 backplate but then im not sure on the rest, what size collet holder does everyone use?
Im still researching so any ideas and suggestions are welcome especially from people who have done it or have one.
thanks
I want to fit a collet chuck to my lathe but Im not sure where to start, I guess I need to make one?
Ive seen this
A L00 backplate but then im not sure on the rest, what size collet holder does everyone use?
Im still researching so any ideas and suggestions are welcome especially from people who have done it or have one.
thanks