Hello this is my first post so please be gentle with me.
My gysmi 164 does not power up. Investigation found the 4.7 ohm resistor to be open circuit and a relay switches on when the unit is plugged into the mains and switches off when on/off is switched on.
After searching the net I came across this forum and found an old thread where member PTvor explained very well about the soft start set up and where to carry out a few checks, like checking the voltage across the big capacitors. I have not had chance yet to carry out the checks.
Can anyone else give any advice.
Cheers
My gysmi 164 does not power up. Investigation found the 4.7 ohm resistor to be open circuit and a relay switches on when the unit is plugged into the mains and switches off when on/off is switched on.
After searching the net I came across this forum and found an old thread where member PTvor explained very well about the soft start set up and where to carry out a few checks, like checking the voltage across the big capacitors. I have not had chance yet to carry out the checks.
Can anyone else give any advice.
Cheers