It's fine. Most of the bigger places just dump it outside until it gets dipped anyway.question to throw out there. How clean does metalwork need to be before being sent to the galvanisers? Is surface rust acceptable?
Just riles me when they don't look properly then bag a big raggy hole off centre hole in a stupid place, instead of using thier eyes.I want to be a self employed hole driller for Leeds galv, a quid a hole i'll be a millionaire in no time.
On the subject of galvanising,what size of clearance do I leave for a sliding bar through box,12mm bar though 25mm box,
so it isn't stuck after galv? Or should it be se[perate and welded in position later?
gary
OK, if you have a part that must fit in a hole or tube after Galv this is what you do.On the subject of galvanising,what size of clearance do I leave for a sliding bar through box,12mm bar though 25mm box,
so it isn't stuck after galv? Or should it be se[perate and welded in position later?
gary