Specialist
Member
- Messages
- 53
Ok, I have found a good offer on Varmig 1400, it is a gas only MIG/MAG welder, goes up to 140 A@8%, which does not concern me too much, as it is needed for thin bodywork. It does 45A@100%, which is about right, since it will be to work on 1 mm plate at most. I guess 30A minimum is adequate for bodywork?
It is a really good price, so I need opinions from people who had experience with this welder. Thank you.
Here is the link:
http://www.varstroj.si/index.php/varmig-1400.106.html
It is a really good price, so I need opinions from people who had experience with this welder. Thank you.
Here is the link:
http://www.varstroj.si/index.php/varmig-1400.106.html