K kevin T New Member Messages 1 Jun 1, 2009 #1 i just got a electra beckum topline mig welder a mig 195 (never had a welder before) i switched it on and it all seems to work okay but the cooling fan doesnot go round is it operated on a thermostat or should it go all the time ??
i just got a electra beckum topline mig welder a mig 195 (never had a welder before) i switched it on and it all seems to work okay but the cooling fan doesnot go round is it operated on a thermostat or should it go all the time ??
zardoz Old school Socialist Messages 2,217 Location Chetser, UK Jun 1, 2009 #2 give it a twirl. in this heat it should soon start the fan up. Never seen one of your make so hard to say, some are set to run at a certain temp.
give it a twirl. in this heat it should soon start the fan up. Never seen one of your make so hard to say, some are set to run at a certain temp.
Robotstar5 Casanunda Staff member Messages 21,575 Location Birmingham Jun 1, 2009 #3 Most welders I've seen, the fan starts at switch on.