Hi all I'm experiencing a very frustrating problem with my 135te, it was ok last week but today I've tried using it and it seems to be playing up! i went through all Hi, Low 1 & 2 settings and tried all the wire feed speed numbers on the machine and i can not seem to find a sweet spot, I'm not getting anywhere close to a frying bacon sound I'm getting a spatter sound and poor welds especially on fillet welds as soon as i start moving it just starts spattering, I've installed a new 5kg reel of 0.6mm wire (yes the wire is in the 0.6mm side of the drive roller) I'm using a clarke disposable bottle of co2 at the minute and i had 6L / min flowing, i tried slightly loosening & tightening driver roller tension too but no joy
Any suggestions would be greatly appreciated!
Any suggestions would be greatly appreciated!