inchpincher
2-stroke terror
- Messages
- 471
- Location
- Tring, UK
Hi guys.
I was welding some thin panels today and the weld had quite a few bubbles in. I etchprimed with a product called 'etchweld' which is supposed to be the best on the market for welding through but I'm thinking that I'm not getting a good earth with the clamp. Sound right or just bad technique (i'm green to this!)?
Thanks, ben.
Using:
Clarke 160T, argonshield light @ 10L/min, 6mm wire. Power 1min, 3-4 wirespeed.
I was welding some thin panels today and the weld had quite a few bubbles in. I etchprimed with a product called 'etchweld' which is supposed to be the best on the market for welding through but I'm thinking that I'm not getting a good earth with the clamp. Sound right or just bad technique (i'm green to this!)?
Thanks, ben.
Using:
Clarke 160T, argonshield light @ 10L/min, 6mm wire. Power 1min, 3-4 wirespeed.