decca
Member
- Messages
- 907
- Location
- Crawcrook, Gateshead.
Got my lathe home today and started cleaning it up a bit.
The only proplem i have found so far is the backgear oil hole does not look right and when you try to put oil in it goes everywere except in the hole.
Is this meant to be one of the ballbearing type oil points or just a hole? If anyone with a boxford aud could post a pic for me that would help a lot.
Got some bits with it
They all need a good clean too
It has the origional light but it isnt wired in. Its 3 phase so i need to get an inverter. Any recomendations for that would be appreciated.
The only proplem i have found so far is the backgear oil hole does not look right and when you try to put oil in it goes everywere except in the hole.
Is this meant to be one of the ballbearing type oil points or just a hole? If anyone with a boxford aud could post a pic for me that would help a lot.
Got some bits with it
They all need a good clean too
It has the origional light but it isnt wired in. Its 3 phase so i need to get an inverter. Any recomendations for that would be appreciated.