Noods
Member
- Messages
- 979
- Location
- Ipswich
Hi all..
I treated myself to a set of Bosch hole cutters the other day. Used the 32 mm one on steel and it cut through beautifully.. Second time out I used it on 2.4 mm stainless steel.. 2/3 of way through it was blunt! I used it via my pillar drill and also used cutting fluid on both cuts, didn't apply much pressure and gave it little breaks in cutting too..
Would this be a call for complaint do you think, or is this considered the norm..?
Thanks
NÒÓDs X
I treated myself to a set of Bosch hole cutters the other day. Used the 32 mm one on steel and it cut through beautifully.. Second time out I used it on 2.4 mm stainless steel.. 2/3 of way through it was blunt! I used it via my pillar drill and also used cutting fluid on both cuts, didn't apply much pressure and gave it little breaks in cutting too..
Would this be a call for complaint do you think, or is this considered the norm..?
Thanks
NÒÓDs X