KemppiFrog
Member
- Messages
- 4,155
- Location
- Aquitaine
Simple little job, 20x1mm steel tube bent on a 115mm CLR.to 90deg
Two probs, I have never bent nickle plated tube and wonder if it will effect the surface on the outside, as in, nickle is much harder and may crack?? Second prob, is I only have the two bits supplied by the client, to make the two curves needed. So no practicing.
Any thoughts from the expert panel?
KF
Going out to a film in a few minutes, so will look back after 22.00hrs
Two probs, I have never bent nickle plated tube and wonder if it will effect the surface on the outside, as in, nickle is much harder and may crack?? Second prob, is I only have the two bits supplied by the client, to make the two curves needed. So no practicing.
Any thoughts from the expert panel?
KF
Going out to a film in a few minutes, so will look back after 22.00hrs