'Bout Ya
Very interesting posts about what to look for in a Mig, but what about an Arc / Inverter Welder? Are they all much of a muchness or are there some better than others?
I need to get something that I can run off a 13amp plug. It will be used outside, mostly on box section (3mm ish wall), possibly up to 6mm plate, but no heavier. It's for greenhouse / leantoo frame thingys.
Can anyone suggest a straight Arc setup to go for ... or possibly an Inverter, that I could use later on if I bought the Tig kit to suit? (To be used on mototbikes and an old Fire engine)
Please don't advise me to go for a gassless Mig. With all the posts I've been reading lately I am thinking of saving my pennies to buy a Portamig in the future.... however, this of course will entail me getting permission from 'er in doors to build me new workshop / garage first.
Any advice / suggestions appreciated.
Tony
Very interesting posts about what to look for in a Mig, but what about an Arc / Inverter Welder? Are they all much of a muchness or are there some better than others?
I need to get something that I can run off a 13amp plug. It will be used outside, mostly on box section (3mm ish wall), possibly up to 6mm plate, but no heavier. It's for greenhouse / leantoo frame thingys.
Can anyone suggest a straight Arc setup to go for ... or possibly an Inverter, that I could use later on if I bought the Tig kit to suit? (To be used on mototbikes and an old Fire engine)
Please don't advise me to go for a gassless Mig. With all the posts I've been reading lately I am thinking of saving my pennies to buy a Portamig in the future.... however, this of course will entail me getting permission from 'er in doors to build me new workshop / garage first.
Any advice / suggestions appreciated.
Tony