Hi all i have an Afrox220 oil cooled welder and it has stoped working
on all the setting except the highest one.
As you can see there are five taps comming off the coil,
from what i can see there is no obvious breakages in the coils
its a sealed box so ive only cut a small hole where i had cut before to make a repair in the earth conection.
Can anyone advise me how to check for breaks in the coils
without cutting the whole box open?
thanks Gary
on all the setting except the highest one.
As you can see there are five taps comming off the coil,
from what i can see there is no obvious breakages in the coils
its a sealed box so ive only cut a small hole where i had cut before to make a repair in the earth conection.
Can anyone advise me how to check for breaks in the coils
without cutting the whole box open?
thanks Gary