ChasesDragons
Member
- Messages
- 98
Hi all,
I have lost my Angle grinder. Can someone gimme advice on a good 115mm angle grinder please, and where to buy one from?
I was thinking BOSCH, MAKITA, HITACHI. But at my budget of £30-40, in-hand, it might be a bit of a dream. Alternatives?
I saw the BOSCH GWS8-115 at Machinemart for about 50 quid. I would prefer to buy one for 30-40 if poss.
Use:
Fine cutting disks to cut and repair 1.2mm and 3mm body and chassis. And bulk cutting 2 or 3mm sheet and pipes for storage (rare).
Any advice appreciated. Theres a lot of rusted nuts, bolts, bulkhead bits to be hacked off my Land Rover project right now.
Warmest Regards
Udhi
I have lost my Angle grinder. Can someone gimme advice on a good 115mm angle grinder please, and where to buy one from?
I was thinking BOSCH, MAKITA, HITACHI. But at my budget of £30-40, in-hand, it might be a bit of a dream. Alternatives?
I saw the BOSCH GWS8-115 at Machinemart for about 50 quid. I would prefer to buy one for 30-40 if poss.
Use:
Fine cutting disks to cut and repair 1.2mm and 3mm body and chassis. And bulk cutting 2 or 3mm sheet and pipes for storage (rare).
Any advice appreciated. Theres a lot of rusted nuts, bolts, bulkhead bits to be hacked off my Land Rover project right now.
Warmest Regards
Udhi