elebub
Member
- Messages
- 94
Kemppi MinarcMig 150
0.6mm wire
10 lpm Argon mix gas flow
20 gauge mild steel
As promised, pics of latest test piece.
Took onboard all the advice i.e. 0.6 wire, two hands on the gun and elbow resting on the bench, smaller gap between plates and a slower torch speed. Not exactly scar-like but I am pleased that there is hardly any distortion between the plates.
Your comments would be most welcome.
Andy
0.6mm wire
10 lpm Argon mix gas flow
20 gauge mild steel
As promised, pics of latest test piece.
Took onboard all the advice i.e. 0.6 wire, two hands on the gun and elbow resting on the bench, smaller gap between plates and a slower torch speed. Not exactly scar-like but I am pleased that there is hardly any distortion between the plates.
Your comments would be most welcome.
Andy