northwest
Searching for the Holy Grail.........
- Messages
- 5,447
- Location
- Manchester UK
As if I haven't had enough on this week I picked up the parts for another project this evening, a 2" x 72" Belt Grinder. I have yet to decide on which motor I am going to use but it is going to be 2 horsepower three phase run from an inverter. The bit I am stuck on now are the wheels and where to source them from, or make my own. The Laser cut kit of parts:
There are enough bits for two machines here, my pal is building one at the same time so it will work out a little cheaper for us, we hope.
Would welcome suggestions as to sourcing the drive and idler wheels though.
There are enough bits for two machines here, my pal is building one at the same time so it will work out a little cheaper for us, we hope.
Would welcome suggestions as to sourcing the drive and idler wheels though.