gaz1
Member
- Messages
- 18,123
- Location
- westyorkshire
ive got these 2 machines to repair and get up and running , as i dont know much about these machines im asking upon here
im advised this is in working order but has a wire sticking problem so could be a simple liner to replace within
240v single phase
this one is a 3 phase model supposed to be in working order, i think this is missing its gun, needs new setting knobs and a volt meter dial near the bottom
the guy is wanting to sell both machines, as i dont know much about these machines im just looking at getting them repaired up to possible use them or mainly to show them in working condition to sell them
i wouldnt mind getting the 240v in working use and use it in situation but all depends on cost and how cost effective it is to repair
im advised this is in working order but has a wire sticking problem so could be a simple liner to replace within
240v single phase
this one is a 3 phase model supposed to be in working order, i think this is missing its gun, needs new setting knobs and a volt meter dial near the bottom
the guy is wanting to sell both machines, as i dont know much about these machines im just looking at getting them repaired up to possible use them or mainly to show them in working condition to sell them
i wouldnt mind getting the 240v in working use and use it in situation but all depends on cost and how cost effective it is to repair