I have a Clarke 160T with a major problem - there appears to be no gas when welding , but there is plenty of gas flow when the trigger is pulled ?
I've changed the cylinder to no avail , I had to go buy another welder to finish the job I was doing when it packed up - so I know its not a regulator or gas problem since the new welder works fine on the same bottle.
I have no idea where to look for faults.................
I've changed the cylinder to no avail , I had to go buy another welder to finish the job I was doing when it packed up - so I know its not a regulator or gas problem since the new welder works fine on the same bottle.
I have no idea where to look for faults.................