e5c0rt.mk1
Member
- Messages
- 168
- Location
- UK
Hi,
i need to make a few bits on the lathe, so i need to get it up and running properly.
At the moment it has a big single phase motor "fitted", but it's far to big and not wired up to any of the switch's.
I have its original 3 phase motor, so i would like to refit this and wire it up with VFD to run it off single phase. However i don't have a clue about VFD's, which are good or bad etc.
The motor on the lathe is a 3 phase 0.75hp, star/delta 380-415v 220-240v
Would this VFD be suitable? or can anyone recommend a different one?
http://www.ebay.co.uk/itm/UPDATED-1...977342?hash=item4d3888e4be:g:ToAAAOSw-0xYeX93
Thanks Owen
i need to make a few bits on the lathe, so i need to get it up and running properly.
At the moment it has a big single phase motor "fitted", but it's far to big and not wired up to any of the switch's.
I have its original 3 phase motor, so i would like to refit this and wire it up with VFD to run it off single phase. However i don't have a clue about VFD's, which are good or bad etc.
The motor on the lathe is a 3 phase 0.75hp, star/delta 380-415v 220-240v
Would this VFD be suitable? or can anyone recommend a different one?
http://www.ebay.co.uk/itm/UPDATED-1...977342?hash=item4d3888e4be:g:ToAAAOSw-0xYeX93
Thanks Owen