johnburke
New Member
- Messages
- 10
- Location
- Dublin, Ireland
Looking for some advice regarding a fault with my welder and was told this was the place to come.
So I have an SIP T194 Inverter mig welder. I use for car work such as roll cages and light steel work, nothing too heavy.
Went to use it the other day, set everything up as usual, pull trigger and as soon as wire touches earth the over temp light comes on and no arc.
Fan, wire feed and gas still working just no arc. Turn off and on again, welder is stone cold and same again when wire touches earth clamp, no spark even, just immediate over temp and cut out.
Any help would be much appreciated.
So I have an SIP T194 Inverter mig welder. I use for car work such as roll cages and light steel work, nothing too heavy.
Went to use it the other day, set everything up as usual, pull trigger and as soon as wire touches earth the over temp light comes on and no arc.
Fan, wire feed and gas still working just no arc. Turn off and on again, welder is stone cold and same again when wire touches earth clamp, no spark even, just immediate over temp and cut out.
Any help would be much appreciated.