hi ive purchased 5 liters of Zinc phosphate oxide primer.. i used it yesterday with a roller and found it very thick i thinned it with petrol and it seemed to roll easier..
im using it on box iron for a high seat ive made for hunting so its nothing to special or high tech.. anyway im going to try my hand at spraying the rest of them to get some practice.. i was just wondering what ratio i should mix it to..
so it will run through the spray gun which i borrowed from my dad.. its one of those clarke kits i think where it feeds the aint up from the cannister underneath....
also my compressor is only a handy lidl one will it be good enough for the job..
once ive everything primed i will be putting a top coat Oxide gloss enamel.. what shoud this be mixed to so it will run nicely through the gun
im using it on box iron for a high seat ive made for hunting so its nothing to special or high tech.. anyway im going to try my hand at spraying the rest of them to get some practice.. i was just wondering what ratio i should mix it to..
so it will run through the spray gun which i borrowed from my dad.. its one of those clarke kits i think where it feeds the aint up from the cannister underneath....
also my compressor is only a handy lidl one will it be good enough for the job..
once ive everything primed i will be putting a top coat Oxide gloss enamel.. what shoud this be mixed to so it will run nicely through the gun