Hi,
I was recently given an SIP Mig Mate 100, after much initial playing around and struggling I've upgraded the wire feed to an independent power supply, PWM motor controller and brought a big bottle of 95% Argon 5% C02 gas, the welder has been transformed and I now feel like I'm getting somewhere.
Ultimately I've got some rust repairs that I'd like to do on an MX5 so I've been practising on some 0.9mm sheet. Below are some photos of what I've achieved so far, I'd greatly appreciate some feedback and advice on how I can improve.
Example 1
Example 2
Example 3
Example 4
Thanks for looking,
Binney
I was recently given an SIP Mig Mate 100, after much initial playing around and struggling I've upgraded the wire feed to an independent power supply, PWM motor controller and brought a big bottle of 95% Argon 5% C02 gas, the welder has been transformed and I now feel like I'm getting somewhere.
Ultimately I've got some rust repairs that I'd like to do on an MX5 so I've been practising on some 0.9mm sheet. Below are some photos of what I've achieved so far, I'd greatly appreciate some feedback and advice on how I can improve.
Example 1
Example 2
Example 3
Example 4
Thanks for looking,
Binney