puffernutter
Puffernutter
- Messages
- 1,804
- Location
- Wiltshire
I've just treated myself to a SheetCam licence and I am struggling with the software.
I have a simple shape that is essentially oval and two holes in the middle. I cannot see how to start and stop the plasma cut to stop it slicing through the material. I'm using Mach 3 and have M8/M9 set up for plasma on/of and another (I'll have to check - it's been a while since I sued it) for air on/off.
Also, the cutting s/w complains about an M3 and an M40 on teh same line, but in the .tap file, there is no M40!!
I can't see anything in the help files - is this a manual addition I have to do?
Cheers
Peter
Confused of Trowbridge!
I have a simple shape that is essentially oval and two holes in the middle. I cannot see how to start and stop the plasma cut to stop it slicing through the material. I'm using Mach 3 and have M8/M9 set up for plasma on/of and another (I'll have to check - it's been a while since I sued it) for air on/off.
Also, the cutting s/w complains about an M3 and an M40 on teh same line, but in the .tap file, there is no M40!!
I can't see anything in the help files - is this a manual addition I have to do?
Cheers
Peter
Confused of Trowbridge!