Mrmonkeyboy
New Member
- Messages
- 29
- Location
- Chesterfield, UK
Hello againIf you've not soldered before, it's a good idea to practise on some scrap PCBs first, as there's WEE everywhere!
Having three heat proof hands and good close vision is a real bonus.
sorry to be a pain, I've had these arrive today and they are very small in comparison to the original ones. I had a thought I wanted to ask you. If I were to cut the one ones off leaving the pins in the board could I solder these to the pins, it would leave them at the right angle for me to adjust if I did. If they are any good obviously. Am I right to assume that they do the same job and are simply smaller due to better technology today rather than when they were 1st made
Thanks again for your help and advice