Kram
Member
- Messages
- 6,240
- Location
- Sussex
Trying to turn a 30mm x 250mm bar with the live centre. I got bad chatter as the tailstock is moving on the bed tailstock is a cam lock. I remember the clamping plate was a crusty lump that looked as cast, so that may be the problem.
There is limited space so I have to move the lathe bench to get it off - its against a wall. Any ideas before I do it?
Thanks
There is limited space so I have to move the lathe bench to get it off - its against a wall. Any ideas before I do it?
Thanks