paulmitchell1984
Member
- Messages
- 814
- Location
- Leeds
Hey guys,
Right I recently bought a kemppi monarch 150 and upgrade from my buzz box Clarke welder.
When I do.practice runs on flat plate or box 3mm wall I get good results..but when I come to.do.a joint I get an issue where it misses the middle part (when joining box together side by side) and occasionally when welding into a corner.
It seems to start off ok but then goes to s$€t.
Using it at 80amp and 2mm rods..if I go any higher it blows the box section out.
Tried it on numerous occasions some seem to work some dont trying to travel at same speed
Right I recently bought a kemppi monarch 150 and upgrade from my buzz box Clarke welder.
When I do.practice runs on flat plate or box 3mm wall I get good results..but when I come to.do.a joint I get an issue where it misses the middle part (when joining box together side by side) and occasionally when welding into a corner.
It seems to start off ok but then goes to s$€t.
Using it at 80amp and 2mm rods..if I go any higher it blows the box section out.
Tried it on numerous occasions some seem to work some dont trying to travel at same speed