Hi,
I have just bought a defective WSE 200P AC/DC TIG/MMA welder. I bought it for the accessories to use with my Migatronic scratch start TIG. I only paid about 50£ so well worth the money even thou it is defective.
The thing is it does power up, i can adjust the current from 0-200. But there is no go atleast in MMA mode. I havent tried it in TIG mode yet because i havent got any electrodes. The seller(no TIG experience) never had any luck with it in TIG mode so most likely something is wrong with the TIG part as well.
Im hoping there might be something that is possible to fix, because it seems like a better choice to TIG with than my Migatronic.
Does anyone have a schematic for this machine? or a likely fault? where to start looking for faults? At visual inspection i cant seem to find anything obvious. But then again i just did open it today. I will take it further apart tomorrow, to see if i can spot some loose contacts or bad soldering.
In advance, thanks.
Jan Rune
I have just bought a defective WSE 200P AC/DC TIG/MMA welder. I bought it for the accessories to use with my Migatronic scratch start TIG. I only paid about 50£ so well worth the money even thou it is defective.
The thing is it does power up, i can adjust the current from 0-200. But there is no go atleast in MMA mode. I havent tried it in TIG mode yet because i havent got any electrodes. The seller(no TIG experience) never had any luck with it in TIG mode so most likely something is wrong with the TIG part as well.
Im hoping there might be something that is possible to fix, because it seems like a better choice to TIG with than my Migatronic.
Does anyone have a schematic for this machine? or a likely fault? where to start looking for faults? At visual inspection i cant seem to find anything obvious. But then again i just did open it today. I will take it further apart tomorrow, to see if i can spot some loose contacts or bad soldering.
In advance, thanks.
Jan Rune