Evening all.
I want to add some U -section to the Harvey Frost to give extra support to stop a tow hitch from twisting while towing.
The picture below shows the U-section in place with a cable tie to get a rough idea where its going to sit.
What I would like to do is taper the U-section to fit closer to the red tube.
How do I calculate the amount/angle of metal to cut off the U-section to get a snug fit along the length of the red tube?
I want to add some U -section to the Harvey Frost to give extra support to stop a tow hitch from twisting while towing.
The picture below shows the U-section in place with a cable tie to get a rough idea where its going to sit.
What I would like to do is taper the U-section to fit closer to the red tube.
How do I calculate the amount/angle of metal to cut off the U-section to get a snug fit along the length of the red tube?