Ok im new to mig welding and have looked all over this site to get ideas and ive just bought my first mig welder, reasons for this are that i am going to restore my vw beetle myself because its just too expensive to get it done by a company!
The panels are quite thin and after reading some info ive decided that i may have the wrong set up..currently i have 0.8 wire and co2 gas, am i supposed to be using 0.6 wire with argon/co2 mix for the thin steel panels?
I havent started welding any of the panels yet but i started practising on some thicker steel with quite good results so i just thought id check with the pros on this site! thanx
The panels are quite thin and after reading some info ive decided that i may have the wrong set up..currently i have 0.8 wire and co2 gas, am i supposed to be using 0.6 wire with argon/co2 mix for the thin steel panels?
I havent started welding any of the panels yet but i started practising on some thicker steel with quite good results so i just thought id check with the pros on this site! thanx