First of all I am new to the forum, though I have readed a couple of times before
I have been wielding some when I went to school for a couple of years ago, so I have touched a MIG machin before
I bought a Kemppi Miniarcmig 150A a couple of months ago (jused), and I just can't gett a nice and clean wielding. Just alot of pores.
Im starting to wonder its the wielding machine that may cause it?
- Im in a garage so it's not windy
- about 1mm plate, and its cleaned.
- Secure 18 gas
- New gas Pressure Gauge
- Trayed from about 7 - 20 lb/min (?)
Not the best picture, can take better tomorrow
I have been wielding some when I went to school for a couple of years ago, so I have touched a MIG machin before
I bought a Kemppi Miniarcmig 150A a couple of months ago (jused), and I just can't gett a nice and clean wielding. Just alot of pores.
Im starting to wonder its the wielding machine that may cause it?
- Im in a garage so it's not windy
- about 1mm plate, and its cleaned.
- Secure 18 gas
- New gas Pressure Gauge
- Trayed from about 7 - 20 lb/min (?)
Not the best picture, can take better tomorrow