NorthYorksPaul
Member
- Messages
- 41
Last week I was doing ok with the SIP 170,then co2 ran out and put Co2/Argon mix on today.....could'nt get it going at all,it kept welding the wire to the tip eventually welded the whole dam thing up wire to tip/tip to shroud what a mess!
need a new bit that the tip screws into and the shroud screws onto..the wire feed was not working too good so increased the tension on roller a little,that helped.....but then disaster.....anyone any idea what I did wrong was fine other day...and can I get the bits or is it a new torch?....thanks.
need a new bit that the tip screws into and the shroud screws onto..the wire feed was not working too good so increased the tension on roller a little,that helped.....but then disaster.....anyone any idea what I did wrong was fine other day...and can I get the bits or is it a new torch?....thanks.