Hi mig-welding people
i've got a little aldi compressor, and (think) I read somewhere on here the fittings (pipe/elbow's/joints etc) were all changed for ones with a larger ID and to facilitate the flow of air a little easier.
So I wondered whether there would be a benefit of upgrading the fittings? (namely, i'd like to use a copper pipe in my little garage to connect rubber hoses to, as opposed to using the standard flexi pipe clipped up, to feed the air reg/water remover/inline oiler (seperate lines)
and where do I purchase these items from? i'm based very near to sheffield, on-line would be easier due to work commitments, but real people in real shops would be cool too )
many thanks,
Jonathan
i've got a little aldi compressor, and (think) I read somewhere on here the fittings (pipe/elbow's/joints etc) were all changed for ones with a larger ID and to facilitate the flow of air a little easier.
So I wondered whether there would be a benefit of upgrading the fittings? (namely, i'd like to use a copper pipe in my little garage to connect rubber hoses to, as opposed to using the standard flexi pipe clipped up, to feed the air reg/water remover/inline oiler (seperate lines)
and where do I purchase these items from? i'm based very near to sheffield, on-line would be easier due to work commitments, but real people in real shops would be cool too )
many thanks,
Jonathan