Bitz n pieces
New Member
- Messages
- 3
- Location
- London uk
Hi all
After using my brothers sealey mightymig150 and got some real nice welds on both thin and thick material I looked around and found a second hand one that looked like it had very lil use and still had half a roll of the gas less type wire in it
Which I used then replaced with some proper wire .8 and some gas a new regulator and swapped the polarity as per the instructions
BUT I don't seem to be getting the same sort of penetration as I did with my brothers one
So was wondering if there's any way of checking the actual output
After using my brothers sealey mightymig150 and got some real nice welds on both thin and thick material I looked around and found a second hand one that looked like it had very lil use and still had half a roll of the gas less type wire in it
Which I used then replaced with some proper wire .8 and some gas a new regulator and swapped the polarity as per the instructions
BUT I don't seem to be getting the same sort of penetration as I did with my brothers one
So was wondering if there's any way of checking the actual output