dutchman
t(r)igger happy
- Messages
- 470
Does anyone have an idea about how I can straighten and “un-dent” this stainless steel stanchion? The diameter is about one inch, 1.6mm wall thickness.
My first idea was to heat it up with the welder and jam another rod in the bottom end (is open) and than straighten it, but if there is a better way, please let me know.
I only have standard tools, such as a hammer, bench vice (and a tig welder).
If I mess it up I have to buy 8 new ones, so I’d better be careful…
My first idea was to heat it up with the welder and jam another rod in the bottom end (is open) and than straighten it, but if there is a better way, please let me know.
I only have standard tools, such as a hammer, bench vice (and a tig welder).
If I mess it up I have to buy 8 new ones, so I’d better be careful…