johnakay
Member
- Messages
- 1,715
Hi its been awhile since I've been on here.
the question is that I want to flattened the end of tube about 1 1/2"
its a bugger doing it in a vice. thought about buying a fly press but it would be too big for my garage.
also I want to cut a notch about 3/4" long. I make grab handles and rear carriers for old bikes etc. any ideas how I could get around this without going to spends loads of money.
I've thought about using a small 5 ton bottle jack.....
your ideas and info will be greatly appreciated. john
the question is that I want to flattened the end of tube about 1 1/2"
its a bugger doing it in a vice. thought about buying a fly press but it would be too big for my garage.
also I want to cut a notch about 3/4" long. I make grab handles and rear carriers for old bikes etc. any ideas how I could get around this without going to spends loads of money.
I've thought about using a small 5 ton bottle jack.....
your ideas and info will be greatly appreciated. john