Davek0974
****!, Drink!, Girls!
- Messages
- 918
- Location
- Hertfordshire
I have a job lot of 100 parts that are L-shaped and the upper part of the L is powder coated on the front only.
Are there any tips/secrets for masking these bits up, the vertical leg of the L is 180x90mm
I tried masking tape on the front then coat/remove and bake but the rear got some powder too.
Any tips
Are there any tips/secrets for masking these bits up, the vertical leg of the L is 180x90mm
I tried masking tape on the front then coat/remove and bake but the rear got some powder too.
Any tips