dave_sussex
Member
- Messages
- 61
Hi,
I recently got a few safes from a hotel that had closed, they had been thrown about a bit, i had to cut the bottom off one to see how the mech worked to gain access. (then due to a weakness i could open all the others without using force)
One safe was out of square so i used a 40mm bit of box and a car jack to wind it back into square.
Then i had to weld the 3mm bottom plate back on, my grinder disk was quite thick so i had to put down a lot of weld to bridge the gap.
Enjoy the pics below...
I recently got a few safes from a hotel that had closed, they had been thrown about a bit, i had to cut the bottom off one to see how the mech worked to gain access. (then due to a weakness i could open all the others without using force)
One safe was out of square so i used a 40mm bit of box and a car jack to wind it back into square.
Then i had to weld the 3mm bottom plate back on, my grinder disk was quite thick so i had to put down a lot of weld to bridge the gap.
Enjoy the pics below...