Paul Table
New Member
- Messages
- 18
- Location
- Hampshire
Looking for advice please.
Not sure if this is posted in the correct section, so please move if necessary.
I have a project on at the moment where I need to joint aluminium sheet in small areas and I'm thinking soldering would be a solution considering the equipment I have to hand. I wonder if this is a possibility, any ideas please.
This is it half finished.
Not sure if this is posted in the correct section, so please move if necessary.
I have a project on at the moment where I need to joint aluminium sheet in small areas and I'm thinking soldering would be a solution considering the equipment I have to hand. I wonder if this is a possibility, any ideas please.
This is it half finished.