Smurfsterst
New Member
- Messages
- 1
- Location
- Nottingham
Good evening all, this is my first post, I've had a good look at previous posts but couldn't see anything the same as my issue.
So.. ........
I know this welder is older than the bible, and about as old as the dinosaurs, but I haven't got the cash to be buying a new set, plus as I'm learning I don't want it to break the bank. Lol.
The set powers up, I can hear the fan, I squeeze the trigger I can hear a click, but I get no feed.
My questions being
1. Is there any cut outs or anything that could be because of bad connections or short circuits? And where should I be checking
2.the set has been stood for a few years so is there any points that's could need a clean etc?
3. Is there any manuals/where is best to get spares/mods to make it work better.
Many thanks all.
Murph.
So.. ........
I know this welder is older than the bible, and about as old as the dinosaurs, but I haven't got the cash to be buying a new set, plus as I'm learning I don't want it to break the bank. Lol.
The set powers up, I can hear the fan, I squeeze the trigger I can hear a click, but I get no feed.
My questions being
1. Is there any cut outs or anything that could be because of bad connections or short circuits? And where should I be checking
2.the set has been stood for a few years so is there any points that's could need a clean etc?
3. Is there any manuals/where is best to get spares/mods to make it work better.
Many thanks all.
Murph.