snoozer
Member
- Messages
- 440
- Location
- Northants UK
Typical as i was reading a post recently regarding Regulator failures and mine died today on a small task for a customer.
I assume the diaphragm has a pin hole in it as i got a loud rush of gas when welding, Switched off the bottle and had a look to find bottle pressure getting through the regulator to the welder no matter where i set the gauge.
Ordered a new regulator but it's left the Bike without a stand until it arrives darn it
Here's the side stand pre-modification, Needs a good few mm added as the Bike has been jacked up at the rear..
I assume the diaphragm has a pin hole in it as i got a loud rush of gas when welding, Switched off the bottle and had a look to find bottle pressure getting through the regulator to the welder no matter where i set the gauge.
Ordered a new regulator but it's left the Bike without a stand until it arrives darn it
Here's the side stand pre-modification, Needs a good few mm added as the Bike has been jacked up at the rear..