Hi Guys
I'm getting my new MIG & gas tomorrow
This may be a daft question but I can't find the answer covered anywhere on the forum. There are many discussions about power settings and wire feeds but no mention of the shielding gas flowrates.
So what i'm asking:
Is the flow rate important to the weld quality? Can the gas flow be too little or too much flow - the latter wasting gas.
Also would a flow rate regulator be a bonus? - it was recommended by a friend.
Thanks in advance.
I'm getting my new MIG & gas tomorrow
This may be a daft question but I can't find the answer covered anywhere on the forum. There are many discussions about power settings and wire feeds but no mention of the shielding gas flowrates.
So what i'm asking:
Is the flow rate important to the weld quality? Can the gas flow be too little or too much flow - the latter wasting gas.
Also would a flow rate regulator be a bonus? - it was recommended by a friend.
Thanks in advance.