Like a lot of people, my introduction to air compressors was the (cheap and nasty?) Aldi set up. After a couple of years (as predicted) it gave up the ghost, however when I didn't have one I found out just how much I missed it. Whilst checking the net for a replacement I stumbled across your forum which I spent many hours reading. I decided after reading your advice that I needed to do it properly and have been lucky enough to buy a good second hand Clarke SE16C150 ( No, NOT the one listed on this forum from e-bay, mine was cheaper but older!) That was all I did get the compressor, nothing else. I'm hoping for some advice on setting the thing up so I can use it. I've looked through the Machine Mart web site, but am baffled by the choices, what hose do I need, a filter regulator bracket lubrictor, what types/sizes ? Just assume that I know nothing and explain everything ( I did get an owners handbook, so safety side is covered). I intend to use workshop tools and some car panel spraying. Your help would be most welcome as my wife is complaining about the money spent on something thats never used!!!