paulmitchell1984
Member
- Messages
- 804
- Location
- Leeds
Was asked at work to remove 2 outlets from a water pipe (exhaust sort of size diameter and about 2/3mm wall)
But it needed to be water tight, only option at work is mig with .8 or 1.0 wire,
What would be best way to guarantee this is perfectly sealed. With it being for water?
Holes were approx 25mm diameter
But it needed to be water tight, only option at work is mig with .8 or 1.0 wire,
What would be best way to guarantee this is perfectly sealed. With it being for water?
Holes were approx 25mm diameter