Hello all,
has anyone bent steel tube (about 1.75" dia, 16 gauge wall) by the sand fill, heat and bend technique.
I'm just looking for some guidelines. They are for an exhaust manifold; I know that ready made bends are available but if the design has a few 3D curves it becomes quite a job to cut and form them.
Alec
has anyone bent steel tube (about 1.75" dia, 16 gauge wall) by the sand fill, heat and bend technique.
I'm just looking for some guidelines. They are for an exhaust manifold; I know that ready made bends are available but if the design has a few 3D curves it becomes quite a job to cut and form them.
Alec