Hi I've finally completed my set up of my Clarke 151TE and started to practice.
I'm using the Small Co2 that came with it.
0.6 wire. When that runs out I'm on the Argon mix bigger bottle.
I could do with some settings for different thicknesses of metal so I'm not wildly over or under to start.
Figure this should save time and gas while learning.
Photos will follow when I've done a bit.
Thanks in anticipation
I'm using the Small Co2 that came with it.
0.6 wire. When that runs out I'm on the Argon mix bigger bottle.
I could do with some settings for different thicknesses of metal so I'm not wildly over or under to start.
Figure this should save time and gas while learning.
Photos will follow when I've done a bit.
Thanks in anticipation