C cnc_freak New Member Messages 15 Location Greece - Athens May 3, 2015 #1 Hello. I turned on today my R-Tech Tig161 AC/DC and no mater where i but the current regulator the display shows 244. Even if i change to MMA the display is stucked to 240. There is no foot pedal on the machine.
Hello. I turned on today my R-Tech Tig161 AC/DC and no mater where i but the current regulator the display shows 244. Even if i change to MMA the display is stucked to 240. There is no foot pedal on the machine.
C cnc_freak New Member Messages 15 Location Greece - Athens May 4, 2015 #3 Yes, same response, the current indicator shows 244 and when i try to weld the current seams to be very high...
Yes, same response, the current indicator shows 244 and when i try to weld the current seams to be very high...
Wendelspanswick Member Messages 6,486 May 4, 2015 #4 Definetely a fault as the display should only go up to 160, does the current at the torch vary when you turn the pot?
Definetely a fault as the display should only go up to 160, does the current at the torch vary when you turn the pot?
C cnc_freak New Member Messages 15 Location Greece - Athens May 4, 2015 #5 No nothing happens, the current seems like it has stucked to 244Amps, but i cant verify it, just from the way it welds...
No nothing happens, the current seems like it has stucked to 244Amps, but i cant verify it, just from the way it welds...