I recently purchased a used lincoln electric weld-pak 100. Previous owner had wire fed into gun but it was cut off from wire wheel, thus leaving wire inside cable liner and unable to feed new wire. How do I remove the wire or get it to come out? There is not enough wire on either end to physically get a hold of with pliers or anything.
Probably a simply question, but this is my first welder, never welded before, and I need to get this up and running to do some test welds before I tackle a project.
Probably a simply question, but this is my first welder, never welded before, and I need to get this up and running to do some test welds before I tackle a project.