Hello, my name ist Michi from Germany. This is my first post and sorry for my bad english.
I need help by following problem:
My old Kemppi Kempomat 163 S is a very good machine,
but i can't weld metal sheet thinner as 1,1 mm.
The machine has four possible to adjust the Power.
By Step 2 is not enough power to weld through the metal sheet.
On Step 3 is immediately a hole in the metal sheet.
We checked the diodes, but we have fount not a possible failure.
I hope, thier can help me by my problem, thank you very much.
greetings
Michi
I need help by following problem:
My old Kemppi Kempomat 163 S is a very good machine,
but i can't weld metal sheet thinner as 1,1 mm.
The machine has four possible to adjust the Power.
By Step 2 is not enough power to weld through the metal sheet.
On Step 3 is immediately a hole in the metal sheet.
We checked the diodes, but we have fount not a possible failure.
I hope, thier can help me by my problem, thank you very much.
greetings
Michi
Last edited: