Hi I am looking at converting my old Mig to euro connector, is it worth it?
I am trying to work out what voltage solenoid I need and where to connect it. I am measuring 24v Dc to chassis from cable that runs to the nozzle is this the voltage? Actually 21.6v output 1 and 25v output 2 setting.
There is no contactor or relay on this welder. I get poor wire feed and would like to hopefully improve it if possible.
Any advice chaps.
Thanks
I am trying to work out what voltage solenoid I need and where to connect it. I am measuring 24v Dc to chassis from cable that runs to the nozzle is this the voltage? Actually 21.6v output 1 and 25v output 2 setting.
There is no contactor or relay on this welder. I get poor wire feed and would like to hopefully improve it if possible.
Any advice chaps.
Thanks