Using my new (late October) Paton PSI160 Inverter-Welder this afternoon.
I'd just tacked on a small plate to a 3mm Angle frame.... and it just stopped.
No wire feed, no gas. Stays powered up and the LH display (volts/current) works, but all the RH display and controls are dead. Bugger.
I've only run about a three of a reel of wire through it since purchase. I'm a bit gutted.
I've just emailed the supplier TWS with the above, and will see what they say.
I'd just tacked on a small plate to a 3mm Angle frame.... and it just stopped.
No wire feed, no gas. Stays powered up and the LH display (volts/current) works, but all the RH display and controls are dead. Bugger.
I've only run about a three of a reel of wire through it since purchase. I'm a bit gutted.
I've just emailed the supplier TWS with the above, and will see what they say.
