general--lee
Member
- Messages
- 187
myford ml3 lathe headstock alignment??
hi all,
question about lathes?
i seen a myford ml3 lathe not to far away , it has excessive play in cross lisde screws but guy says it still works if its like £120 -£150 is it worth getting ?
how difficult is it to cure play?
do the cross slides of the other myfords fit like ml7 ?
also on average how often do you use the reverse gear feature as teh ml3 dont have it ?
ps i dont want to spend like 4-500 on a lathe just want one to start out on for spacers etc
hi all,
question about lathes?
i seen a myford ml3 lathe not to far away , it has excessive play in cross lisde screws but guy says it still works if its like £120 -£150 is it worth getting ?
how difficult is it to cure play?
do the cross slides of the other myfords fit like ml7 ?
also on average how often do you use the reverse gear feature as teh ml3 dont have it ?
ps i dont want to spend like 4-500 on a lathe just want one to start out on for spacers etc
Last edited: